• Route the antenna cable with the cable end with the plug
through the swivel nut and the desired hole of the two-
hole cable support sleeve.
• Push the two-cable support sleeve along with the antenna cable back into the cable gland. Ensure that any
unused openings of the two-hole cable support sleeve are sealed with sealing plugs.
• Screw the swivel nut of the cable gland on loosely.
• Remove the protective cover of pin connector
ANT.
on the communication assembly (if present).
• Insert the plug of the antenna cable into the pin connector
ANT.
on the communication assembly until it snaps into
place. Observe the prescribed cable route (see
Section 4.1, page 9).
BAT
Max. 30V DC
USB
MFR
A
B
X1
X2
ANT
.
FCC ID: SVF-KP20
IC: 9440A-KP20
SPS
A
B
D-IN
ANT
.
• Fasten the swivel nut on the cable gland hand-tight. This will secure the antenna cable.
4. Installing the antenna bracket:
• Considering the dead spot of the antenna, move the antenna bracket to the desired position on the wall and
hold it firmly.
• Mark positions of drill holes if necessary and drill two holes with 6 mm (0.24 in) diameter each at the
marked points and insert screw anchors.
• Attach the antenna bracket to the wall with the screws.
5. Attaching the antenna cable and the antenna to the antenna bracket:
• On the antenna cable, unscrew the counter nut approx.
5 mm (0.2 in) from the plug.
• Lead the antenna cable plug from the antenna bracket’s
slot. In doing so, make sure that the washer and the
counter nut are on the outside of the antenna bracket and
that the antenna cable is not kinked or twisted.
4 Mounting
SMA Solar Technology AG
Installation Manual
EXTANT-40-IA-en-10
12
