Translated by R.Whitehead 10-3-2014 (my best effort – accuracy is not guaranteed)
23 of 38
10.2. Multiplex M-Link
The GPS-Logger 2 is also a full telemetry sensor for the Multiplex M-Link 2.4 GHz system.
The measured GPS values can be transferred live to the ground and be displayed directly on
the Multiplex the Royal Pro or COCKPIT SX transmitter.
The connection is made direct to the M-Link receiver with the patch cable provided as
described in section 7.
On the ground the data is displayed directly on the Multiplex the Royal Pro or COCKPIT SX
transmitters.
The settings for telemetry can be made either with the UniDisplay ( see chapter 8) or with
our “SM GPS-Konverter” software on a PC. The addresses for display on the Multiplex
remote control (the line that the respective value is indicated in) can also be freely selected.
To make it easier to find a model there is a special Landing Out mode:
In M-Link after 2 minutes without moving, Latitude and Longitude are displayed on the
addresses Vario and Speed every 5 seconds. It changes the display between the decimal
value with the unit “mAh” and the decimal value with the unit “ml”. Meaningful units – such as
degrees and minutes
– are unfortunately not allowed in M-Link.
The values to 4 digits with leading zeros
are replaced, from “4912 mAh” “268 ml” is “4912”
“0268” and in the correct notation
49
°
12.0268
’
.
10.2.1. Alarms
All alarms on M
-link are produced
directly from
GPS-Logger 2
. All settings
are
al
so
made in the
GPS-Logger 2
.
