4
Programming the Remote
There are 4 programming methods available for this remote :
1. Popular brand code search
2. Direct Code Entry
3. Auto code search
4. Learning Mode
Note:
• The remote control is pre-programmed for use with
Microsoft Windows XP & Microsoft Vista PC operating
systems, so no programming is required. You will however
need a Microsoft authorized Media Center Infra Red
receiver or a PC with a built-in with a Infra Red sensor.
1. Popular Brand Code Search (
Recommended
)
Note:
• If you are programming the remote for a brand/model that is
not listed in the Popular Brand List or the Direct Code Entry
(e.g. Wharfedale, Acoustic Solutions etc), it is recommended
that you use the Auto Code Search method (go to section 3)
or the Learning Mode (go to section 4).
• This search method is supported only in TV, SAT, DVD and
VCR Modes. You can not use this method for other devices
(If AUX is assigned to a TV, SAT, VCR or DVD, the brand
code search is also supported in AUX mode)
• There are 20 popular brands for TV, and 10 brands for SAT,
VCR and DVD listed in the Popular brand list.
Please follow the steps below
1. Turn on the device you want the remote to control, for DVD/
CD/VCR, insert a disc/tape at the same time.
2. Look up the correct number corresponding to your brand
and device type from the Popular Brand List (For example,
if your TV brand is PHILIPS, the correct number is 00, if
your VCR brand is SONY, the correct number is 2)
3. Press and hold one of the Device Keys for 3 secs (e.g. TV).
The LED turns ON when the key is pressed but turns
OFF after 3 secs indicating that the key can be released.
4. Release all keys. LED turns back ON.
5. Enter two DIGIT (00-19) keys corresponding to the TV
brand, the LED turns OFF for each key press and turns
ON after release. (e.g. 00 for PHILIPS TV)
6. If VCR, DVD, Cable or Satellite, enter one DIGIT (0-9)
key corresponding to the (SAT, CBL, DVD, CD, VCR)
brand,
the LED turns OFF for each key press and turns ON after
release. (e.g. 2 for SONY VCR)
7. Aim the remote control at your device, the Led blinks
indicating the code search has started.
8. When your device reacts (e.g. TV turns off or channel
changes), the correct code has been found, press the
corresponding device key immediately to store the code
and the remote will exit the search mode. The LED
