SLX 27868HS User Manual Download Page 4

 If you are in any doubt  about an installation,  

  refer to a qualified aerial/satellite installer. 

 Installations must comply with EN 50083 and  

  National Safety Regulations.

 When working on an installation outside,  

  beware of overhead power lines.  

 Observe safe working practices, tread carefully  

  and ensure adequate lighting is available in loft  

  or roof space.  

 Always follow manufacturer’s operating and  

  safety instructions before using tools and/or  

 equipment.  

 Only carry out work outdoors at height if you  

  are competent in the use of ladders and related  

  access equipment.  

 Always read and follow the manufacturer’s 

  instruction label affixed to the ladder. 

 To avoid injury always route cables or wiring  

  carefully. Ensure cable is correctly routed before  

  fixing into position, taking care not to over  

  tighten cable clips . 

General Safety Precautions

© Philex Electronic Ltd. 2016 v4.3

Waste electrical products should not be 

disposed of with household waste. Please 

recycle where facilities exist. Check with 

your Local Authority for recycling advice.

 

Contents

1 x DVB-T/SAT Finder

1 x Compass  

1 x F lead 

1 x F plug  

1 x F to coax adaptor

Customer Careline: 08457 573 479  (Local rate - UK Only)           Technical Support: www.philex.com/support

For further information or any queries, please contact

Philex Customer Careline: 08457 573 479

 

(Local rate – UK only)

Technical Support: www.philex.com/support

Summary of Contents for 27868HS

Page 1: ...nsertion Loss dB 3dB Sat 6dB TV Return Loss Input dB 8 Output dB 8 Input Level Terrestrial dBμV 50 80 SAT dBμV 70 100 Power Requirement 15V DC 40mA Battery used For DVB T Only PP3 9V Sensitivity Control Satellite DVB T Switch Signal Strength LEDs Power LED Satellite Aerial Digital TV Signal Meter USER GUIDE 27868HS Customer Careline 08457 573 479 Local rate UK Only Technical Support www philex com...

Page 2: ...tion 7 Slowly scan from side to side across the sky to the Azimuth angle plus 5 e g Brighton 145 16 5 so finish at about 150 degrees the full 10 scan should be slow enough to take a couple of minutes to allow your receiver to lock onto and measure signal quality You are aiming to find the position where the most LED s on the Finder are lit up and correspondingly if you are on the correct satellite...

Page 3: ...signal levels select the one with widest zone of signal strength and position the aerial in the centre of this zone To connect cables to the meter you will need to use F connectors not supplied To find where your nearest transmitter is and the channels available locally visit http www digitaluk co uk and fill in the coverage checker details To find out your nearest transmitter s distance and compa...

Page 4: ...llow the manufacturer s instruction label affixed to the ladder To avoid injury always route cables or wiring carefully Ensure cable is correctly routed before fixing into position taking care not to over tighten cable clips General Safety Precautions Philex Electronic Ltd 2016 v4 3 Waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check...

Reviews: