Universal Live Timing Box Rev 2.0 User manual
As shown in figure 44, the buttons can be divided in three groups: DRIVER 1, DRIVER 2 and
COMPARE. These are not enabled at the same time, but only as follows:
•
those belonging to the first group, DRIVER 1, are enabled only if the user loads the data in
the DRIVER 1 section of the "
Postprocessing
" page, using the
browse "Path_file1"
button;
•
those belonging to the second group, DRIVER 2, are enabled only if the user loads the data
in the DRIVER 2 section of the "
Postprocessing
" page, using the
browse "Path_file2"
button;
•
those belonging to the third group, COMPARE, are enabled only if the user loads the data in
both DRIVER 1 and DRIVER 2 sections of the "
Postprocessing
" page. This is the case of
the comparison of, for example, the data of two different drivers;
In the "
Postprocessing2
" page (figure 44), the following data can be seen:
•
brake performance (“BRA” graph);
•
minimum and maximum speed set by the user and real-time performance of the applied
speed in conformity with the chosen anti-spin value (“OTH” graph);
The buttons of the "
Postprocessing2
" page have the following meaning:
•
DRAW GRAPH:
this function draws the above data as found the selected lap. In particular,
the brake value is displayed in the "BRA" graph, the other values in the "OTH" graph. If no
lap number has been selected, a message informs the user that, in order to continue, it is
necessary to specify the lap number to be visualized. The selected lap number is also
displayed in the "
Selected 1
st
lap #
" field;
53
Figure 44:
postprocessing 2.
