Universal Live Timing Box Rev 2.0 User manual
5.3 Data storage on the Universal Live Timing Box's internal memory
The function of lap and possible sector times storage is available whatever controller is being used.
In case that the
Universal Live Timing Box
is used together with a SCP-01 controller, it is also
possible to see and store the data complete with telemetry.
Case a
: lap/sector time playback and storage / PC chronometer.
Valid for any controller with a clarification in case that the user is using the
Universal Live Timing
Box
connected to the USB connector of the SCP-01. In this case it is necessary to position both
switches (7) on
OFF
.
N.B: in case of a controller which is not SCP-01, the function PC chronometer will be available
from the firmware version of
Universal Live Timing Box
1.0.3.
Case b
: lap/sector time playback and storage. PC chronometer. SCP-01 telemetry.
Valid only for SCP-01 with “
connection cable
”(12) connected to the SCP-1 controller's cartridge
according to instructions.
Below, the connections the user has to make according to the case:
1.
Connections to make in case a:
•
in case that one wants to connect the
Universal Live Timing Box
to the
Track Interface
through the SCP-01 controller, see point (2);
•
insert the USB white cable’s male plug (10) of the
Universal Live Timing Box
into the
USB female plug of the “
Track to telemetry cable
” coming from the
Track Interface
. The
final result is shown in figure 7.
2.
Connections to make in case b:
•
connections:
•
insert the USB white cable’s male plug of the
Universal Live Timing Box
(10) in
the USB female plug of the SCP-01 controller;
•
insert the USB male plug of the “
connection cable
” (12) welded to the SCP-01
controller’s cartridge (for instructions, see the following point) into the USB female
plug of the “
Track to telemetry cable
” coming from the
Track Interface
. In case one
wants to avoid the use of the “
connection cable
” (12) of the
Universal Live Timing
Box
, the user can follow what described in point (1);
•
welding “
connection cable”
(12) to SCP-1 controller's cartridge:
with reference to
figure 9 and 10, the black wire must be welded in point 2, the red one in point 1. Figure
9 can be referred to in case of use of positive or negative analogue cartridge, figure 10 in
case of high-current cartridge. IMPORTANT: The welding must be done keeping the
cartridge not connected to the power supply; play the welding safe acting only on the
indicated circuit points;
N.B. Data Storage cannot be enabled in case of
multilingual
dictionary on the internal memory of
the
Universal Live Timing Box
.
11
