10
MAINTENANCE
STEP 3.
Cleaning the nozzle of Manual
Models (Fig. 20)
A clogged nozzle may result in poor
dispensing or malfunction.
To clean the nozzle:
Soap
1. Open the cover and clear the
dispensing hole at the end of the
nozzle with a thin wire pin (less than
0.5 mm) – paper clips work well.
2. Close the cover.
3. Check if the unit dispenses properly. If
the unit does not dispense properly,
replace the pouch.
Sanitizer
1. Open the cover and soak only the
nozzle in hot water for approximately
two minutes.
2. If the clog is still visible, clear the
dispensing hole at the end of the
nozzle with a thin wire pin (less than
0.5 mm) – paperclips work well.
3. Close the cover and test again.
4. If the unit does not dispense properly,
replace the pouch.
Thin wire pin/
paperclip
Nozzle
Nozzle
Hot water
Fig. 20
