background image

INSTALLATION INSTRUCTIONS FOR EAF-350 SERIES ELECTRONIC, 

BATTERY-POWERED, SENSOR-ACTIVATED LAVATORY FAUCETS

Code No: 0816654

Rev. 3 (04/15)

Faucet Variations

-

ISM

 

Integral Spout Temperature Mixer

Limited Warranty

Unless otherwise noted, Sloan Valve Company warrants its products, manufactured and sold for commercial or industrial uses, to be free from defects of material 
and workmanship for a period of three (3) years (one (1) year for SF faucets, special fi nish and PWT electronics and 30 days on PWT software) from the date of 
fi rst purchase. During this period, Sloan Valve Company will, at its option, repair, replace, or refund the purchase price of any produce which fails to confom with 
this warranty under normal use and service. This shall be the sole and exclusive remedy under this warranty. Products must be returned to Sloan Valve Company, 
at customer’s cost. No claims will be  be allowed for labor, transportation or other costs. This warranty extends only to persons or organizations that purchase 
Sloan Valve Company’s products directly from Sloan Valve Company for purpose of resale. This warranty does not cover the life of batteries.

THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO EVENT IS SLOAN VALVE COMPANY RESPONSIBLE FOR ANY 

CONSEQUENTIAL DAMAGES OF ANY MEASURE WHATSOEVER.

PRIOR TO INSTALLATION

Prior to installing the Sloan OPTIMA Plus® EAF-350 Series faucets, install the 
items listed below. Also, refer to rough-in illustrations.
• Lavatory/sink
•  Drain line
•  Hot/Cold water supply lines or pre-tempered water supply line

IMPORTANT:
•  ALL PLUMBING SHOULD BE INSTALLED IN ACCORDANCE WITH APPLICABLE 

CODES AND REGULATIONS.

•  FLUSH ALL WATER LINES PRIOR TO MAKING CONNECTIONS.
•  KEEP THREAD SEALANT OUT OF YOUR WATERWAY TO PREVENT 

COMPONENT PART DAMAGE! DO NOT USE ANY SEALANT ON 
COMPRESSION FITTINGS.

Trim Plates

When the EAF faucet is installed on a sink that has three (3) hole punchings, 
a trim plate should be used. 

Trim plates must be specifi ed and ordered 

separately.

ETF-312-A    Trim Plate for 4” (102 mm) Centerset Sink
ETF-510-A    Trim Plate for 8” (203 mm) Centerset Sink

Tools Required for Installation

•  13mm open wrench or nut driver for faucet retainer nut
•  3/4” open end wrench for female end of fl ex hose

Summary of Contents for OPTIMA plus EAF 350 Series









Reviews: