background image

4

CODE CHART

Codes are displayed by the flashing of the red LED light in the sensor behind air outlet.
Normal operation will be indicated by the red LED being on when not drying and off when hands are under the sensor.

SLOAN VALVE COMPANY • 10500 Seymour Avenue • Franklin Park, IL 60131

Phone: 1-800-9-VALVE-9 or 1-847-671-4300 • Fax: 1-800-447-8329 or 1-847-671-4380

sloan.com

0816863 Rev.1 (11/18)

Copyright © 2018 SLOAN VALVE COMPANY

The information contained in this document is subject to change without notice.

ADJUSTING THE HEAT OUTPUT, MOTOR SPEED AND SENSOR RANGE

The dryer is shipped with maximum heat and maximum motor speed. To adjust, turn the corresponding knob

COUNTERCLOCKWISE to reduce. H = HEAT M = MOTOR R = RANGE

TROUBLESHOOTING (CONT.)

If problems cannot be resolved with the above troubleshooting steps, please call Sloan

at 1.888.756.2614 and one of our trained technicians will be happy to assist you.

4

Summary of Contents for OPTIMA AIR EHD-700 Series

Page 1: ...d this shall be the sole remedy available under this warranty No claims will be allowed for labor transportation or other incidental costs This warranty extends only to persons or organizations who purchase Sloan Valve Company s products directly from Sloan Valve Company for purpose of resale THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF IN NO EVENT IS SLOAN VALVE ...

Page 2: ...ggle Bolt Wooden Wall Lag Screw With Washer 2 Check that the electrical supply corresponds to that shown on the rating sticker of unit If the dryer is connected to any electrical supply other than that stated on the rating sticker ofthe unit permanent damage or improper unsafe operation ofthe unit may result Make sure electricity is switched off at the main panel before installing maintaining or c...

Page 3: ...Labeled M on control Turn clockwise to increase 2 Check for slow running Motor or burning smell If so replace Motor 3 Check Pre Filter for lint buildup Clean by removing Pre Filter and rinse in warm water then dry Pre Filter before reinstalling WARNING TO REDUCE THE RISK OF FIRE ELECTRIC SHOCK OR INJURY TO PERSONS OBSERVE THE FOLLOWING A Use this unit only in the manner intended by the manufacture...

Page 4: ... 671 4380 sloan com 0816863 Rev 1 11 18 Copyright 2018 SLOAN VALVE COMPANY The information contained in this document is subject to change without notice ADJUSTING THE HEAT OUTPUT MOTOR SPEED AND SENSOR RANGE The dryer is shipped with maximum heat and maximum motor speed To adjust turn the corresponding knob COUNTERCLOCKWISE to reduce H HEAT M MOTOR R RANGE TROUBLESHOOTING CONT If problems cannot ...

Reviews: