{ Design. Uniqueness. Innovations }
9
10
SERIES
ACCESSORIES
Manager ID card setup
1. Shortly press “ID card reader setup button” (on the back side of the outdoor panel, see page 5) to enter
manager ID card setup mode. User will hear a short sound and status LED becomes blue.
2. Take the ID card that should be used as manager card and touch it near card reader zone on the front
of the door panel. If manager card setup was successful then user will hear a sound signal. (If user
doesn’t touch ID card near card reader during 10 seconds then door panel will be automatically
switched into standby mode). Only one manager ID card can be added to the card reader memory.
“Unlock ID cards setup” and “delete card” modes
1. In standby mode situate management card near the card reader to enter “unlock cards setup” mode.
Outdoor panel will emit double sound and backlight of the call button will become blue.
2. Put every unlock ID card that needs to be added near card reader one by one. After each card reading,
a double sound signal can be heard. In case if current ID card has been already added to the card reader
memory then four-time sound signal can be heard while touching it near the card reader.
3. When all unlock ID cards have been added then put management card near the card reader to enter
“delete card” mode. Door panel will emit double sound a asignal and status LED will become red.
4. Put any unlock ID card that needs to be deleted near card reader while “delete card” mode is active.
After double short sound current ID card will be deleted from the memory.
5. While
“delete card” mode is active, situate management card near the card reader to exit into standby
mode.
6. Wait for 10 seconds without any actions in «unlock ID cards setup» or «delete card» modes to exit into
standby mode automatically.
7. Maximum unlock ID cards quantity that can be added to the card reader memory is 248 pcs.
8. Sound and visual indication
Door unlock successfull – one “beep” and blue status LED blinks twice
No such unlock card – triple short “beep” and status LED blinks red
twice
Standby mode – status LED doesn’t work
“Unlock ID cards setup” mode – double “beep” and status LED is
constantly blue
“Delete card” mode – double “beep” and status LED is constantly red
Card setup successfull – double “beep”
Card is already added – four times short “beep”
9. Unlock time setting
Depending on the lock type connected to the door panel different unlock time should be used. While using
an electromechanical lock, unlock time must be set under 2 seconds (1 second is typical value) to prevent
electromechanical lock damaging. For the electromagnetic lock set unlock time to let visitors open the door
during this time (typically it is 3-5 seconds).
Unlock time setting can be made in such way:
1. Shortly press “ID card reader setup button” (on the rear side of the door panel, see page 5) to enter
unlock time setting.
2. On 2 users door panel use the 1st user button on the front to increase unlock time or the 2nd user
button to decrease unlock time.
3. On 4 users door panel use the 2nd user button on the front to increase unlock time or the 3rd user
button to decrease unlock time.
4. While unlock time setting you can hear sound signals from the door panel speaker. Sound signals
quantity displaying current unlock time value in seconds. Unlock time value can be set up for 1 to 5
seconds.
–
