IMPORTANT!
When using the supplied inflatable adapters, the valve
depressor adapter (fig. X) must be used in conjunction with the
inflatable adapters. Failure to use the supplied valve depressor adapter
with inflatable adapters will result in over-pressurization and failure of
the Flat Tire Repair Kit. To install, remove the valve depressor adapter
assembly from the back of the Flat Tire Repair Kit. Unscrew the Presta
valve adapter and set aside. Thread the valve depressor adapter into the
air hose of the Flat Tire Repair Kit
(fig. Y) until fully seated. Thread on the desired inflatable adapter until
snug and inflate item.
AIR ONLY INSTRUCTIONS:
Check your tire warranty prior to installation of this product.
The AIR ONLY mode can also be used for bicycles, sports balls, rafts and other inflatables.
Screw air/sealant hose onto tire’s valve stem.
Select AIR ONLY.
NOTE: Lay Flat Tire Repair Kit
on the ground facing upward.
Plug inflator into 12 volt accessory power outlet. Do not run
vehicle while inflator is operating. You may need to be in
“accessory” or “on” position. Please make sure emergency brake
is set and car is in park.
Push green button to turn system on. Fill to desired pressure.
Turn system off and check tire pressure. Once correct tire
pressure has been achieved, disconnect air hose and power
plug.
1
2
3
4
Fig. X
Fig. Y
