Remove the Vertical Tilt Handle from the back of the Pan & Tilt Handle
where it is stored.
Install the Vertical Tilt Handle
Check to see that there is a washer ring on the shaft of the Vertical Tilt
Handle, and then insert the shaft into the threaded hole located on the
right side of the Pan Head. Screw handle all the way in until secure.
To remove the Quick Release Platform from the Pan Head, turn Quick
Release Lock Lever and lift out Platform from its back.
Attaching the camera to the Quick Release Platform
Align the length of the Platform along the base of the camera body, and
securely tighten the Mounting Wing Nut.
When attaching the camera to the Pan Head, check to make sure that the
Quick Release Platform is engaged in the catch of the Pan Head before
locking the lever.
Using the Pan Head
The Quick Release Platform can be attached to the camera body in either
directions (along the length, or along the width).
This feature facilitates your camera set up into the vertical position, simply
by the turn of one of the Tilt Handles.
Loosen the Pan & Tilt Handle, and the head will tilt back and forth.
Loosen the Panning Lock Knob, and the head will rotate along the horizontal
direction.
Washer Ring
Caution
Loosen the Vertical Tilt Handle, and the level can be adjusted.
Using the Pan Head (Continued)
When loosening either the Pan & Tilt Handle, or the Vertical Tilt Handle, take
precaution by keeping a firm grip on the handle until the Pan Head is locked
down.
Removing the Head from the Center Column
Use the following instructions if you wish to change heads, or attach
accessories.
First, lock the Panning Lock Knob, then grasp the Pan, or Vertical Tilt
Handle and turn the head, counter-clockwise to loosen.
Set the new head, or accessory on the tripod's threaded post, and turn
clockwise until it comes to a stop.
Tighten the Panning Lock Knob and turn clockwise slightly more.
Three Position Adjustable Legs
Flip up the Leg Lock Lever to extend or shorten any of the individual leg
sections to the desired length, and press the Leg Lock Lever flush against
the Leg to lock.
After choosing the desired leg angle, securely push in the Adjustment
Lock.
Caution
Extending the Tripod Legs
It is easier to extend the tripod legs if you turn the leg-tips to the foot,
while leaving legs close.
To change the angle of each leg, close the Leg slightly, and then pull the Leg
Angle Adjustment Lock out.
There is a choice of two other angle positions.
