SleepSafer Hi Lo
Assembly Instructions Continued...
STEP 1
Set electric frame (#1) upright with foam
spacer blocks (#12) underneath each cor-
ner of the mounting brackets as shown.
Using the 8 silver hex bolts (#11), attach
front panel (#4) and back panel (#5) to
brackets on frame. Now, check the align-
ment of the decking on the electric frame
to each end of the panels. Even up the
spacing and tighten the 8 hex bolts. Un-
strap the handset from the frame and set
it out of the way.
STEP 2
Install 16 barrel nuts (#17) into holes at the
ends of all panels. Install headboard (#2) and
footboard (#3) to side panel/frame assembly
(A) using the 12 long allen bolts (#10) provided.
Do not tighten the bolts completely. Insert
two alignment pins (#7) into the holes in the
bottom back panel as illustrated in the diagram
above. Set the top back panel (#6) onto the
alignment pins, orienting the panel as shown in
the inset diagram. Insert 4 more of the long
allen bolts (#10) into the back panel. The
headboard and footboard will be elevated off
the floor when installed. Tighten all of the allen
bolts using the 4mm allen wrench (#13) pro-
vided in your hardware kit.
Install the 4 casters (#9) into the holes in the
bottom of the headboard and footboard legs.
You may now remove the foam spacers from
underneath the frame.
NOTE: In the diagram at right, the
head section will be to the right side
of the bed when you are facing the
safety rails. If you need to have the
head section of the bed to the left
side when facing the safety rails, re-
verse the panel installation from the
diagram.
