Use edge of scissors to lift out inserts from upper
and lower devices. Then store for possible future
use. Try on the lower mouthpiece to see if it needs
to be widened in order to have your molars fit into
the grooves of the lower mouthpiece.
If you device does not have inserts then skip step
If it does not then hold the front end of lower
into
boiling water for 10 sec. Adjust the shape to fit over
your back teeth.
Hold the back end of lower mouthpiece into the hot water until the plastic turns
clear. Then cut off the plastic behind each wing and place the lower device on a
non stick surface. (glass, porcelain. or stone)
Molding Instructions V9
Remove Inserts, check size of lower device
Insert Lower into hot water
Trim backend of Lower
