Step 1. Upper Splint Molding
Heat water in a microwave safe container until boiling.
Don
’
t place in boiling water
. Let the
water sit for at least a minute to bring the temperature to around
130
degrees.
Remove the
cams
(wheels) using the hex key. Now place
half
of the plastic beads and the upper mouthpiece
in the hot water. In approximately one minute the inner white plastic will turn clear. Remove it
and place on hard surface
. (fig. 1)
#1
Remove the soft plastic beads and form into a
thin
long tubular shape by rolling and pulling. Then
place it along the inner surface of the upper mouthpiece.
blue line
(fig. 2,3,3a)
#2
#3
#3a
