9
TV Bed MK4 Remote Control Guide
MK4
When necessary, you will need to use a 2032 battery in the remote for replacement.
1. Connect the mechanism motor inlet cord from the footboard to the 5-Pin Din outlet.
2. Connect the DC power supply to the DC jack, both on the back of the Box.
3. One press on the remote controls
up
button will drive the TV bracket upwards,
press again on the
up
button will pause the upward movement.
4. One press on the
down
button will drive the TV bracket downwards, press again
on the
down
button will pause the downwards movement.
Operation – Refer to wire diagram for parts listing
Synchronize (Pairing) the controller Box to the Handset
Provided that the button on the controller box below the LED has not been PRESSED, the
pair should be synchronized. If you need to synchronize them follow the instructions.
quickly.
This will delete the pairing (so the handset will not work). To reset the pairing follow the next
steps:
1. Press and hold the button on the controller box for three seconds.
4. The pairing is completed and the handset is operative with the control box.
Note the leads to connect both new and old TV remote systems are the same.
Your remote control system is pre-set and you can use this immediately. You will only need to reset
the remote system if your hand set does not respond.
If you have a fault with your product or missing fittings, please contact our customer service team on
01992 450333 (Monday to Friday 08:30 - 17:30 excluding bank holidays).
