Skyworks Si5 Series, Manual

Page: 2 / 19

2 Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
Rev. 0.3 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • October 12, 2021
1. Introduction
This document describes the operation of the Skyworks Si514/570/571/598/599 evaluation kit. The Si5xx-PROG-
EVB kit refers to the evaluation board hardware and software intended for customer evaluation of the
Si514/570/571/598/599 Any-Frequency I
2
C programmable XO/VCXO. The Si5xx-EVB kit contains the following:

Si5xx-PROG-EVB Hardware

Programmable Oscillator Software

EVB Driver (USBXpress
®
)
The software components run on a USB-equipped PC and are described in detail in Section “5. Software Guide”
The Si5xx-PROG-EVB evaluation board can be used to evaluate the Si514, Si570, Si571, Si598, and Si599 I
2
C
programmable XOs or VCXOs as shown in Table 1. The Si514-PROG-EVB evaluation board can be used to
evaluate the Si514 I
2
C-programmable XO as shown in Table 1. This evaluation board functions and performs
similar to the Si5xx-PROG-EVB evaluation board.
Table 1. Si5xx XO and VCXO Device Evaluation Board Selector Guide
Ordering Part # Type Devices
Supported
Packages
Supported
Output Format,
Temp Stability,
Tuning Slope
Supported
Frequency
Range
Si5xx-EVB Single/Dual Frequency
XO/VCXO Eval Board
Si510/511
Si512/513
Si515/516
Si530/531
Si532/533
Si550/552
Si590/591
5 x 7 mm, 6-pin
3.2 x 5 mm, 6-pin
3.2 x 5 mm, 4-pin
Any 100 kHz to
1417 MHz
Si5xx-PROG-EVB I
2
C Programmable
XO/VCXO Eval Board
Si514
Si570/571
Si598/599
5 x 7 mm, 8-pin
5 x 7 mm 6-pin
3.2 x 5 mm, 6-pin
Any 100 kHz to
1417 MHz
Si514-PROG-EVB I
2
C Programmable XO
Eval Board with sol -
dered Si514
Si514 5 x 7 mm 6-pin Any 100 kHz to
250 MHz
Si5xx5x7-EVB Quad Frequency
XO/VCXO Eval Board
Si534
Si554
5 x 7 mm, 8-pin Any 10 to
1417 MHz
Si570-PROG-EVB I
2
C Programmable XO
Eval Board with sol -
dered Si570
Si570 5x7 mm 8-pin Any 10 to
1417 MHz
Notes:
1. Si5xx samples must be ordered separately from the Si5xx-PROG-EVB.
2. Board
must be
modified to be consistent with the ordered part. See "3.10. Output Terminations" on page 8.
3. Si514-PROG-EVB comes with an Si514 preinstalled.