IDP-280/IDP-290 - Hardware Guide
T212, Version 03 46 © ORBCOMM Proprietary
APPENDIX D
IDP-280 Blunt Cut Cable
This cable connects the modem to external I/O lines and serial ports. As the IDP-280
Blunt cut cable is common with the IDP-680, it has are a total of 10 pins although note all
10 pins are supported on the IDP-280.The cable has an over-molded connector, a floating
drain wire and is available in two models, either terminated or unterminated to ground.
Specifications
Parameter
Value
Part Number: ST301005
Cable drain wires (outer shield and I/O - Figure 49)
terminated to ground at modem connector (PIN 3 -
Figure 48).
Part Number: ST301025
Cable drain wires un-terminated/not connected (outer
shield and I/O - Figure 49) to ground.
Length
ST301005-001 5 m
ST301005-002 10 m
ST301005-003 25 m
ST301025-004 25 m
For additional lengths, contact your Account Executive.
Temperature
-40°C to +85°C
Ultraviolet rating
UV stabilized
Figure 48 Face View of Modem Blunt Cut Cable Connector
