Skywalker X-8, Assembly Manual

Page: 14 / 35

8. Mounting the Pushrod and Pushrod Connector
Insert the pushrod into the uppermost hole in the servo arm. Slide the pushrod connector onto the pushrod and
attach the pushrod connector with one of the supplied black screws. Cut off any excess length off the pushrod.
The pushrod should not extend more than 1/8” of an inch past the pushrod connector. See Photo 8A.
PHOTO 8A
9. Gluing the Main Wing Winglet Butt ‐ Plate
Liberally apply a smooth layer of glue to the winglet butt ‐ plate these butt ‐ plates are marked with a “T”. Apply a
smooth layer of glue to the main wing as well. Allow the glue to dry on both the wing and butt ‐ plate (about 5
minutes), then press them together aligning them accurately. See Photos 9A and 9B.
PHOTO 9A