ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
• Need phillips screw driver
(included)
.
• Assembly requires two persons.
• Wear gloves to protect your hands from pinch points during assembly.
TRAMPOLINE PLACEMENT
1. Place the trampoline on a level surface before using it.
2. Adequate overhead clearance is essential. A minimum of 24 feet from ground level is best. Provide clearance from wires, tree
limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline away from walls, struc-
tures, fences, and other play areas. Always have a clear space on all sides of the trampoline.
3. Use the trampoline in an area with lots of light. If the trampoline is indoors or in a shady areas you may need to use artificial
(electrical) lighting in the area.
4. Secure the trampoline against unauthorized and unsupervised use.
5. Remove any objects from beneath the trampoline.
6. The owner and supervisors of the trampoline are responsible to make all users aware of practices specified in this manual.
1.
Make sure that you understand the information in the box at the top of this page.
Lay two Top Tubes with socket (2) and one Top Tube (1) on the
ground in the positions shown. Make sure the Top Tubes are
turned so the small holes (spring holes) are facing the ground.
Insert the small end of the Top Tube (1) into the socket attached
to Top Tube (2) in location C . Insert the small end of the Top
Tube with socket (2) in location A into the large end of the top
tube(1).
The Top Tubes and Sockets should now appear as shown in
step 2, below.
2.
Slide two “J” Shaped Leg tubes (3) onto a Brace (4) as
shown. The peak of the Brace (4) should point toward the
ground. Screw the two Screws (7) into the two Legs (3) and
Brace (4).
Insert one of “J” Shaped Leg tubes (3) halfway into one of
the Sockets on the top tube (2) assembled in step 1. Insert the
other Leg halfway into the other Socket. Press down on both
Legs at the same time and fully insert them into the Sockets.
Note: You may need to strenuously pull outward on the Legs as you
insert them into the Sockets.
Repeat steps 1 and 2 three additional times to assemble three
more leg sections.
11
1
2
2
2
3
4
3
Push Here
Push Here
Pull
Here
Pull
Here
Peak
2
7
7
A
B
C
Small End
Large End
Small End
