IN VEHICLE INSTALLATION (CONTD.)
Please read and follow the notes below for the safe operation of your 82 Elite DASH CAM within
your vehicle.
As per the installation instructions, you must install the 82 Elite DASH CAM so it does NOT obstruct
the drivers view of the road, preferably on the passenger side of the vehicle and behind the rear view
mirror. Whilst the 82 Elite DASH CAM clearly needs to view through the windscreen in an area swept
by the windscreen wipers, the 82 Elite DASH CAM should be installed so as not to intrude
significantly within the wiped area. A 40mm intrusion into the green wiped area is the maximum
permitted by law.
Do NOT mount the B2 Elite DASH CAM in front of the driver, as depicted by the red area in the
above illustration.
When installing the B2 Elite DASH CAM in a vehicle, always place the device securely against the
windscreen and where possible conceal the power cable under trim. Make sure that the B2 Elite
DASH CAM power cable does not interfere with the drivers operating controls, such as the steering
wheel, pedals or gear levers.
Do NOT mount the B2 Elite DASH CAM in front of an airbag field of deployment or in a position to
obscure any mirrors.
Clean the windscreen at the point of location, prior to fitting the B2 Elite DASH CAM, also, applying
some moisture to the suction cup may be beneficial, to ensure absolute adhesion.
It is recommended NOT to operate the B2 Elite DASH CAM whilst driving. The automatic Start-Stop
technology incorporated within the device negates any need to operate the controls whilst driving.
Adjust any settings or review recordings whilst stationery, not whilst driving.
Only use your mobile device whilst stationery, not whilst driving.
After the preliminary SETUP has been carried out upon the B2 Elite DASH CAM, adjust the Screen
Saver setting to 1 minute, this will blank the screen automatically shortly after starting the vehicle and
therefore the screen will NOT be a distraction in any way to the driver.
4
