SkyTrac Systems Ltd.
Document Rev. 02.010
ISAT-100-OPD-SOI
Page 8 of 26
Restricted Proprietary and Confidential Information
6. Create the wire harness for the ISAT-100. Refer to ISAT-100 Optional Equipment
Wiring Diagram (DOC0029) if the applicable STC drawings are not available.
7. If a PDA is going to be connected to the ISAT-100, check the data port using a
PDA loaded with ITrax software. Refer to the ITRAX manual for more information.
8. If a PDA is used:
•
Make sure it has a serial connector
•
RS 232 cable should not exceed 40 ft.
1. Must use shielded RS 232 cable
4.4 ISAT-100 Installation
The ISAT-100 is designed to be secured by its mounting rails to the airframe using six
(6) AN-3 bolts and should be installed using the ISAT installation kit (P/N KIT-ISAT-
100). Figure 4-1: ISAT-100 Mounting Rails illustrates the locations for mounting
screws in the mounting rails on the sides of the ISAT-100.
It is important to achieve a good electrical bond between the ISAT-100 enclosure
and the airframe. Remove paint if necessary and prepare the mounting holes.
The document reference is online, please check the correspondence between the online documentation and the printed version.
