Skytech: TS-R-2A Wireless Thermostat
REV. 11-14-18 Page 2
TO REMOVE THE BATTERIES IN THE WIRELESS THERMOSTAT
1. Remove face from backing plate this is done by sliding the face up about 1/2” then pull the face off the base plate. As
shown in Figure.
2. Locate the (2) holders for the 3V button cell batteries.
3. Insert a small screwdriver into the slot above the button cell battery and push the battery out. As shown in Figure 2.
TS-R-2A THERMOSTAT OPERATION
1. ROOM TEMP – Current room temperature.
2. F° = Degrees Fahrenheit (C° = Degrees Celsius)
3. FLAME ICON – Indicates APPLIANCE IS ON.
4. SET- Indicates TS-R-2A is in thermostat mode.
5. DASHES – Indicate thermostat mode is being disabled.
Note: The word (SET) will appear when the thermostat mode is
enabled.
ROOM
TEMP
1
2
3
SET
ROOM
TEMP
5
4
1. This TS-R-2A Wall/transmitter has ON, OFF, and SET functions that
are activated by pressing the buttons on the face of the transmitter.
2. Upon initial use, there may be a delay of five seconds before the
remote receiver will respond to the transmitter. This is part of the
system’s design. If the LCD will not come on, check the 3V-button
cell battery.
ON
SET
OFF
SETTING MANUAL OPERATION
1. When the ON button on the TS-R-2A is pressed a flame icon on the
LCD screen will appear when the appliance is ON.
2. When the appliance is OFF the flame icon will not appear.
ROOM
TEMP
GENERAL INFORMATION
WALL MOUNTING THE TS-R-2A THERMOSTAT
1. Remove face from backing plate as shown in Figure 1 then locate
the TS-R-2A to where the (2) thermostat wires from the appliance
can be pulled through the hole on the backing plate and connect
them to the (2) terminal screws.
2. After locating the (2) two mounting holes and mark the holes on
the wall.
3. Use the (2) two dry wall anchors and screws (that are supplied) to
mount the base plate to the wall as shown.
4. Thermostat can also be mounted onto an existing (Plastic)
electrical box.
5. Base plate should be mounted level on the wall for best operation.
6. Reinstall the face to the backing plate this is done by sliding
the face in and down about 1/2” then check that the (2) male
terminal connectors on the face are engaged in the female
terminal connectors on the backing plate. As shown in Figure 1.
ROOM
TEMP
ON
OFF
SET
WALL
