Skytech TM-R-AF1 Installation And Operating Instructions Download Page 2

___________________________________________________________________________________________________________ 

                                        

 

   Rev.

 

11-14-18 Page 2 of 4

   

Skytech TM/R-AF1 

 
WALL MOUNTING THE TIMER 
 

 

 

 

 

1. 

Remove face from backing plate by insetting a small screwdriver into  

 

the small slot at the top or bottom of the faceplate as shown to the right 

 

then snap OFF. 

2. 

Locate the (2) two mounting holes and mark the holes on the wall. 

3. 

Use the (2) two dry wall anchors and screws (that are supplied) to 

 

mount the base plate to the wall as shown.  

4. 

The wall transmitter can also be mounted onto an existing (Plastic)  

 

electrical box.  

5. 

Base plate should be mounted level on the wall for best operation. 

 
 
REMOTE RECEIVER 

IMPORTANT 

 

THE REMOTE RECEIVER SHOULD BE POSITIONED WHERE AMBIENT 

TEMPERATURES DO NOT EXCEED 130° F. 

 

 
The remote receiver (right) operates on (4) 1.5-volt AA batteries.  It is 
recommended that ALKALINE batteries be used for longer battery life and 
maximum microprocessor performance.  IMPORTANT:  New or fully charged 
batteries are essential to proper operation of the remote receiver as a latching 
solenoid power consumption is substantially higher than standard remote control 
systems. 
 

NOTE

:  The remote receiver will only respond to the transmitter when the 3-position slide button on the remote receiver is in the 

REMOTE position. The remote receiver houses the microprocessor that responds to commands from the transmitter to control system 
operation. 

 
FUNCTIONS: 
 

1. 

With the slide switch in the REMOTE position, the system will only 
operate if the remote receiver receives commands from the transmitter.  

Upon initial use or after an extended period of no use, the ON button may 
have to be pressed for up to three seconds before activating solenoid. If the 
system does not respond to the transmitter on initial use, see LEARNING 
TRANSMITTER TO RECEIVER section. 

2. 

Slide switch to ON for manual operation.

 

3. 

With the slide in the OFF position, the system is OFF. 

4. 

It is suggested that the slide switch be placed in the OFF position if 
you will be away from your home for an extended period of time.  
Placing the slide switch in the OFF position also functions as a safety 
"lock out" by both turning the system OFF and rendering the 
transmitter inoperative. 

 

INSTALLATION INSTRUCTIONS 

 

WARNING 

 

DO NOT CONNECT REMOTE RECEIVER DIRECTLY TO 110-120VAC POWER.  THIS WILL BURN OUT 
THE  RECEIVER.    FOLLOW  INSTRUCTIONS  FROM  MANUFACTURER  OF  GAS  VALVE  FOR 
CORRECT WIRING PROCEDURES.  IMPROPER INSTALLATION OF ELECTRIC COMPONENTS CAN 
CAUSE DAMAGE TO GAS VALVE AND REMOTE RECEIVER. 

 

INSTALLATION 

 
The remote receiver can be mounted on or near the fireplace hearth.  PROTECTION FROM EXTREME HEAT IS VERY IMPORTANT.  
Like any piece of electronic equipment, the remote receiver should be kept away from temperatures exceeding 130º F inside the 
receiver case.  Battery life is also significantly shortened if batteries are exposed to high temperatures. 
 
Make sure the remote receiver switch is in the OFF position. For best results it is recommended that 18 gauge stranded wires should 
be used to make connections and no longer than 20-feet. 

 

REMOTE

ON

OFF

LEARN

Requires 4-AA 1.5V

alkaline batteries

Learning

 button

Remote Receiver

Battery cover slides on/off

Slide

Switch

ON

REMOTE

OFF

 

WALL

3V

3V

30

60

120

OFF

 

OFF REMOTE ON

LEARN

Reviews: