Skytech: TM-R-2A
REV. 10-12-18 Page 5
SYSTEM CHECK
MILLIVOLT VALVES
Light your gas appliance following the lighting instructions that came with the appliance. Confirm that the pilot flame is
ON; it must be in operation for the main gas valve to operate.
• Slide the 3-position button on the remote receiver to the ON position. The main gas flame (i.e., the fire) should ignite.
• Slide the button to OFF. The flame should extinguish (the pilot flame will remain on).
• Slide the button to REMOTE (the center position), and then press the ON button on the transmitter to change the
system to ON. The main gas flame should ignite.
ELECTRONIC IGNITION SYSTEMS
• Slide the 3-position button on the remote receiver to the ON position. The spark electrode should begin sparking to
ignite the pilot (the pilot may ignite after only one spark). After the pilot flame is lit, the main gas valve should open
and the main gas flame should ignite.
• Slide the button to OFF. The main gas flame and pilot flame should BOTH extinguish.
• Slide the button to REMOTE (the center position), and then press the ON button on the transmitter to change the
system to ON. The spark electrode should begin sparking to ignite the pilot. After the pilot is lit, the main gas valve
should open and the main gas flame should ignite.
GENERAL INFORMATION
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver to accept
the transmitter security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from
your dealer or the factory. In order for the receiver to accept the transmitter security code, be sure the slide button on
the receiver is in the REMOTE position; the receiver will not LEARN if the slide switch is in the ON or OFF position. The
LEARN button in located on the front face of the receiver; inside the small hole labeled LEARN. Using a small screwdriver
or end of a paper clip gently
Press and Release
the black LEARN button inside the hole. When you release the LEARN
button the receiver will emit an audible “beep”. After the receiver emits the beep press the transmitter ON button and
release. The receiver will emit several beeps indicating that the transmitter’s code has been accepted into the receiver.
LEARNING TRANSMITTER TO RECEIVER
PROGRAMING MULTIPLE TRANSMITTERS TO THIS RECEIVER
NOTE
: This receiver can hold from (1) to (3) different transmitter codes. This is for the times when a hand held transmitter
or a second wall transmitter is required.
Press and release the LEARN button on the receiver.
1. When you hear the “Beep”,
press and hold
the ON or OFF button for about 2 seconds on the transmitter.
2. A confirming series of “Beeps” will come from the receiver to indicate that the receiver has accepted the transmitter
code. Then the receiver will operate with both transmitters.
3. When the LEARN button is pressed and the receiver makes NO “Beep” sound this indicates that the receiver is
unable to accept any more transmitter codes.
4. To clear the codes from the receiver and start programming over or add new transmitters,
press and hold
the LEARN
button in for (10) seconds and release. Then, the receiver will emit a series of three long “Beeps,” indicating that the
receiver has cleared all codes and is ready to accept new codes.
