INSTALLING FLAME CONTROL SOLENOID
ALL STEPS REQUIRED FOR INSTALLATION OF THE FLAME CONTROLLER MUST BE DONE BY
A QUALIFIED GAS SERVICE TECHNICIAN
Remove the screw and knob from the variable regulator and keep in a safe place.
1.
Unscrew the nut from the regulator and keep in a safe place.
2.
Remove the bag containing a washer and blue and red plungers from the side of the flame control solenoid.
3.
Insert the correct plunger (Blue - natural gas, red - propane) into the flame control solenoid.
4.
Thread the flame control solenoid with correct plunger into the thread hole in the variable regulator.
5.
Gas Control Valve
Variable Regulator
Washer
Flame Control
Solenoid
Variable Regulator
Plunger
Jam Nut
Solenoid
Variable Regulator
Nut
Screw
Knob
WIRING SOLENOID TO THE RECEIVER
Connect the two leads from the flame control solenoid to the orange
1.
leads from the receiver.
Plug the remote receiver into the 110/120 VAC power supply.
2.
Light the fireplace.
3.
Tighten the jam nut to the face of the variable regulator body
4.
Turn the main gas knob on the gas valve OFF.
5.
CAUTION
TO ENSURE SAFE OPERATION, THE OUTLET PRESSURES ON
BOTH REGULAR AND HI FLAME LEVELS SHOULD BE CHECKED
WITH A MANOMETER IN ACCORDANCE WITH SPECIFICATIONS
SUPPLIED BY THE VALVE MANUFACTURER.
COMMUNICATION - SAFETY - TRANSMITTER - (C/S - T/X)
This remote control has a COMMUNICATION –SAFETY function built into its software to ensure the transmitter and receiver are
communicating normally.
In all operating modes, the transmitter sends an RF signal every fifteen minutes to the receiver indicating that the transmitter is within
the normal operating range of 20 feet. Should the receiver NOT receive this signal, the receiver will begin a 2 hour countdown. If the
receiver does not receive a signal from the transmitter in 2 hours, the receiver will shut off the appliance. The receiver will then emit a
series of rapid “beeps” for a period of 10 seconds. Then after 10 seconds of rapid beeping, the receiver will continue to emit a single
“beep” every 2 seconds until a transmitter
MODE
Button is pressed to reset the receiver.
Skytech: RCT-MLT III
REV 12-26-13 Page 4
