MODE FUNCTION
NOTE:
Touch anyplace on the screen and the back light will light up and stay lit for 5
seconds.
To select an operational mode, press the
MODE
button or touch the
MODE SECTION
on
the touch screen.
ON
•
turns the appliance on, the flame icon will appear.
THERMO
•
sets the remote to Thermo mode.
OFF
•
turns the appliance off, the flame icon will disappear.
MODE
SET
PROG
Mode: Button
Mode: Touch
Portion
SETTING ºF / ºC SCALE
The factory setting for temperature is ºF. To change this setting to ºC, first press and hold the
UP
touch button and the
DOWN
touch
button on the transmitter at the same time. Follow this same procedure to change from ºC back to ºF.
NOTE:
When changing between the ºF and ºC scales, the set temperature defaults to the lowest temperature (45 ºF, or 6 ºC).
Press and hold the
•
SET
button, or touch the SET section on the touch screen, for 5 seconds. The hour section should begin to
flash. (Fig. #1)
Use the
•
UP
and
DOWN
touch buttons to select the hour, then press
SET
.
The minutes will be flashing. Use the
•
UP
and
DOWN
touch buttons to select the minute, the press
SET
. (Fig. #2)
The AM PM will be flashing. Use the
•
UP
and
DOWN
touch buttons to select one of them, then press
SET
. (Fig. #3)
One of the days of the week will be flashing (above the clock). Select the correct day by pressing the
•
UP
and
DOWN
touch but-
tons, then press
SET
. Your time will automatically be accepted. (Fig. #4)
SETTING THE CLOCK
Fig. #1
Fig. #2
Fig. #3
Fig. #4
THERMOSTAT FUNCTION
This remote control system can be thermostatically controlled when the transmitter is in the THERMO mode
(THERMO must be displayed on the screen). To set the desired room temperature, press the
MODE
button to
place the transmitter into thermo mode, then press the
UP
or
DOWN
touch buttons to select the desired room
temperature. The highest set temperature is 99 ºF (32 ºC).
REV. 3/5/09 Page 2
NOTE: The thermo feature operates the appliance whenever the room temperature varies a certain number of degrees from the set
temperature. This variation is called the “swing” or temperature differential. This feature lets the appliance turn off and on 2 ºF (1 ºC)
above or below the set temperature of the room. This is to cushion the number of times the appliance is turned on and off.
THERMO UPDATING FEATURE - TRANSMITTER
When in thermo mode, the transmitter reads the ROOM temperature every 2 minutes, checks the room temperature against the SET
temperature then sends a signal to the receiver.
