Model:
4001TH-A
TX
REV. 3-31-20 Page 4
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the
fireplace, behind the control access panel.
Position where the ambient temperature inside the receiver case does
not exceed 130º F.
NOTE
: Black slide button (accessory pack) is used
on Hearth Mount Applications.
WALL MOUNTING RECEIVER
Install (4) AA-size 1.5 ALKALINE batteries in the remote receiver. For best performance, remote receiver batteries should
be factory fresh when installed. Very little battery power is required to operate the remote receiver, but the electronics are
tuned to operate best when total battery output is greater than 5.3 volts. Four new AA batteries should provide a total
output voltage of 6.0 to 6.2 volts. Be sure batteries are installed with the (+) and (-) ends facing the correct direction.
To attach Cover Plate to Receiver Box:
Position the receiver as shown in diagram to the left with
lower tab on cover plate inserted into groove of receiver
(Make sure LEARN hole on cover plate properly aligns with
remote receiver) Pull Receiver up and snap into top tab of
cover plate.
Position the cover plate so the word ON is facing up; then,
install the remote receiver into the plastic switch box using
the two long screws provided. Push the white slide button
over the receiver slide switch.
Cover Plate
(Rear View)
Remote
Receiver
WALL
Plastic Switch Box
Remote Receiver
Cover Plate
Receiver
Slide
Button
OFF
REMOTE
ON
OFF
ON
REMOTE
NOTE:
The remote receiver will only
respond to the transmitter when the
3-position slide button on the remote
receiver is in the REMOTE position. If the
system does not respond to the battery
transmitter on initial use, see LEARNING
TRANSMITTER TO RECEIVER, and
recheck battery positions in the remote
receiver.
LED Light
