Model:
4001-A
TX
REV. 3-31-20 Page 1
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION
INSTRUCTIONS DO NOT ATTEMPT TO INSTALL OR OPERATE
INTRODUCTION
This remote control system was developed to provide a safe, reliable and user-friendly remote control system for gas
heating appliances. This all battery system operates independently of household current. The system operates on radio
frequencies with a non-directional signals. The systems operating range is approximately 20-feet. The system operates
on one of 10,000,000 security codes that are programmed into the transmitter at the factory. It is designed to be used with
millivolt gas valves as a dry contact switch.
The transmitter is an ON and OFF. There is an LED light that
will illuminate when pressing either ON/OFF button. It you do
not see the red LED light illuminate check the position of the
transmitter’s battery.
The transmitter operates on (1) 3V Button Cell (included)
that powers the RF signal. Before using the transmitter, the
3V battery must be installed into the battery compartment.
Tools Needed:
Small jewelers screwdriver
To remove the battery holder from the bottom of the
transmitter insert a small jewelers screwdriver into the
notch at the bottom of the transmitter, then gently pry out
the battery holder out. Once it is started, it will pull out
with your fingers. Insert the 3-volt button cell battery in the
battery holder with the plus (+) side up. See the drawings at
the right.
It is recommended that CR2032 lithium battery always
be used for longer battery life and maximum operational
performance.
ON
OFF
ON-OFF Buttons
FRONT
LED (Red) Light
MODEL:
BACK
BACK
FRONT
MODEL:
4001-A
TX
Bottom E
dge
Bottom of
Transmitter
