5 - 16
22.
Headphone-connector: Use the headphone for pre-listening the output singal.
23.
GND: Grounding e.g. for a turn table
24.
MASTER OUTPUT
The MASTER output jacks connect the mixer to your main amplifier using standard audio cables with RCA-type
connector.
25.
LINE / PHONO INPUTS
Located on the rear panel are 1 PHONO and 2 LINE RCA inputs.
SPECIFICATIONS
◆
Input Sensitivity MIC
:
10mV/10K
Ω
◆
Input Sensitivity LINE:
300mV/30K
Ω
◆
Input Sensitivity PHONO: 15mV/22K
Ω
◆
Frequency Response LINE: 20Hz-20KHz +8/-3dB
◆
Bass:
±10dB
◆
Treble:
±10dB
◆
THD+N(1KHz):
<0.05%
◆
OUTPUT:
2V/400
Ω
◆
Max:
10V
Peak-to-Peak
◆
S/N:
>67dB
◆
Headphone Impedance:
16-32 Ohm
◆
Power Requirements:
AC12V-600mA
◆
Dimensions ( Lx W x H ) L202 x W202 x H35 MM
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your
local authorities or your dealer about the way to proceed.
The specifications are typical. The actual values can slightly change from one unit to the other. Specifications can
be changed without prior notice.
WARRANTY CONDITIONS
The date the product leaves the importer is considered to be the date the warranty begins. Only companies approved by
Skytec
are allowed to work on the equipment.
During warranty period (defective) equipment must be returned to the dealer by pre-paid mail in the original box.
Potentiometers have a limited lifetime and are not covered by the manufacturer for more than normal use.
For all service enquiries, refer to your local distributor,as he is best able to help you.
Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would
also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or
disrespect of the warnings contained in this manual. Skytec cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.
Summary of Contents for STM-2250
Page 2: ...2 16 Lay out...
Page 15: ...15 16...