17. Glue C11 Bulkheads into the slots in the cockpit floor and against
the side console panels. See Figure 6.
18. Cut a 2.3 inch piece of 1/4” dowel (supplied) as the stick. Cut an
additional piece 0.6” as the hand grip. Sand to an angle, glue
together, and glue the stick in place.
19. Cut two additional 1 inch pieces of dowel as control pushrods,
and glue to the cockpit floor as shown.
S-2
14. Glue C4 Left Console Side Panel to the cockpit floor and the aft
bulkhead.
12. Glue C2 Aft Bulkhead to the cockpit floor and F6A.
13. Glue C3 Seat Supports to the cockpit floor and the aft bulkhead.
15. Glue C12 Map Holder to C5 Right Console Side Panel at the for-
ward scribe mark.
16. Glue C5 to the cockpit floor and the aft bulkhead.
