10
NC2500
09
NC2500
Useful Notes And Tips
You can only connect your NC2500 charger with one device at a time.
The charger can hold up eight paired devices. When the memory is full and additional device
cannot be paired. If you want to pair new devices, you need clearing all the memory.
Clearing memory
To clear the charger memory of all devices, Press and hold “UP” and “DOWN” button
simultaneous for five seconds, The charger clears all devices from its memory.
Touch slot number button(1-4) to change operation mode and current.
Operation with Your iPhone
When
the
program
for
a
slot
is
completed
,
DONE will
displayed
.
With
the
exception
of
DISCHARGE mode
,
top off
charge
and
trickle
charge
(
continuous
)
will
be
applied
.
For
CHARGE
mode
,
the
total
charged
capacity
will
be
displayed
.
For
REFRESH
&
ANALYZE
,
BREAK
-
IN
,
DISCHARGE
mode
,
the total
discharge
capacity
will
be
displayed
.
DisCharge Rate
mAh
DIS
CHARGE
REFRESHIST.
BREAK-INO.
REST CYCLE
Capacity
Volt
Time
OPERATION WITH iPHONE
Pairing Charger with iPhone
Pairing occurs when two Bluetooth devices communicate with each other and establish a connection.
A record of information about this connection is then stored in the memory of each device. Once you
pair a device with the NC2500 charger, you should not have to pair it again.
The NC2500 charger can pair with up to eight devices. However, it can only connect to, and control
the NC2500 charger from one device at a time.
To begin pairing with your iPhone, iPod or iPad
Connect the power adapter DC connector to the charger and then plug the power adapter into
outlet (100-240V AC, 50/60Hz).
Insert AA or AAA battery
Inserting AA or AAA Batteries
1.
2.
When a new battery is inserted and detected, the
battery sign and “CHARGE” in correspond slot will
blinking. Please wait five seconds, the charger will
proceed to the default mode which is charging.
Push and hold “ENTER” button for five seconds, the
bluetooth LED indicator on the charger is blinking in
blue to show the charger is discoverable.
3.
Select the Bluetooth menu from your iPhone or iPad and ensure the Bluetooth is turned on.
4.
Find the NC2500 Charger which will be identified as “SKYRC + 4 digits serial number”. For
example, SKYRC1234 and select it.
Confirm that you want to connect the NC2500 Charger with your iPhone or iPad by selecting it.
5.
A confirmation “Connected” appears on your phone after you have selected the NC2500 Charger.
It takes few seconds to finalize the pairing process, please wait for while.
The Bluetooth indicator, located on the right side of charger remains steadily on.
Your NC2500 Charger is now connected with your iPhone or iPod.
6.
7.
8.
OPERATION WITH iPHONE
OPERATION WITH iPHONE
Factory default
setting
Touch system
setting icon
to change value of temperature protection, voltage protection,
discharge cut-off voltage and negative delta V.
