ASSEMBLY
STEP 1
Remove the battery hatch and temporarily loosen
the rudder and elevator’s control rods with a 1.5mm
allen key. This will alleviate any binding that may
occur when manually moving the elevator control
rod and rudder control rod in Step 3.
STEP 2
Prepare the model for physical assembly by first binding your receiver to your radio transmitter,
centering the model’s servos, and calibrating the throttle. We also recommend programming a
throttle lock for additional safety. Refer to your radio transmitter’s manual for instructions.
STEP 3
Attach the horizontal stabilizer halves to the fuselage by inserting the carbon rod through the
hole as shown. Fasten each horizontal stabilizer half with two screws as shown.
STEP 4
Your Skynetic 1000mm Havok Racer features a
rigid one-piece main wing that is internally
reinforced with carbon within the main sections
and the ailerons.
Connect the two aileron servos with the included
Y-connector and position the main wing onto the
fuselage as shown.