4.5 code with the wireless panel
Enter the wireless system setting status. chose the panel remote code mode,
trigger the arm or disarm key in the keypad, then the panel will get the wireless
signal , then press the save key in the panel. ( please refer to remote code in panel manual)
Our wireless products have stable performance. But, it will be limited in some range for
their low transmitting ability. As follow
1.the receiver will be blocked or it is out of the scape of the frequency
2.usally test the collision and take protect methods
3.when the power is not stable or the senors is power short, it will be signal fault.
5
clean and protect
when it is dirty, please clean it by sponge using mixed cleaner and water. Note:
please do not make much water leak into the shell to damage the circuit board
6
product work shortage
-2-
4.3 bypass zone
it is available when in the dual-way mode
ENTER
987699
13
OK
enter the zone number by two digits
OK
1
OK
will sound "didi...." , It is successful.
4.4 Dual-way communication mode
( it is our factory default setting)
ENTER
987699
15
OK
1
OK
0
OK
1
OK
The working mode of the keypad
one way
used as a re
mote controller
dual-way communication
Set the door sensor enable or diable( the function has not used yet
Set the tamper is enable or disable
ENTER
987699
15
OK
3
OK
0
OK
1
OK
Disable
Enable
NOTE
disarm
key can be used as
inquiry
key when it is at the status of
dual-way communication
press once
will display the panel status
( as many zone alarm,can press
disarm
to enquiry
.
Note
set the zone attribute to be 1, it is bypass;set to be 0, cancer the bypass.
4.2 set the password:(the passwords for user 2~ user 10 are empty for our factory default setting
Change the user password
ENTER
987699
OK
OK
enter new user
password
OK
Change administrator password
ENTER
987699
12
OK
enter 6 digits new
administrator password
OK
2
11
Finish setting, press
BACK
to back the program status, or the system will back
after 30S itself.
