Skymsen TA-4.0 MB, Instruction Manual

Page: 6 / 16

First of all check if the Blender is firm in its position. It is recommended to work
with the machine on a flat surface with approximately 850 mm of height.
Before using the machine all parts that get in contact with food must be washed
with running water and neutral soap. To clean your Blender read item 3.3 Cleaning on
this Manual.
2.3 You Shall Not
2.3.1 expect your blender to replace any other kitchen appliance. It is not supposed to make
mashed potatoes, it does not blend egg white or any other
cream for covering, it does not grind raw meat, it does not blend hard pastas and does not
extract kernels from fruit and vegetables.
2.3.2 process mixtures for too long. Remember that this kind of blender works in seconds
and not in minutes. Therefore, never let your blender working for more than one minute. It is
better to switch it off and check the mixing consistency after a few seconds to avoid over
blending.
02
1.3 Technical Characteristics
Tabela - 01
2.1 Installation
The Blender is to be installed onto a leveled surface approximately 850mm high.
The High Performance Blenders were developed to be used in both voltages:
127V or 220V. Upon receiving the Blender control the voltage indicated on the cord
label.
The cord has a plug with three pins one of them is grounding . It is
mandatory the three pins to be connected before to start to use the
blender .
2. Installation and Pre-operation
2.2 Pre-Operation
IMPORTANT
When installing the Cup #02 (Pic.01) on the machine be sure it is perfectly
fitted. The Cup can be fitted on the machine in eight positions which
110
50 - 60
1200
1,2
21 7/8”
9”
7 7/8”
8.8
Voltage
Frequency
Power Rating
Consumption
Height
Width
Length
Net weight
Gross weight
[V]
[ c/s ]
[w]
[kw/h]
[Inches]
[Inches]
[Inches]
[lb]
[lb]
17.6
Cup maximum capacity [l]
4