14
TABLE 02
PROBLEMS
CAUSES
SOLUTIONS
- The machine does not start.
- Electric energy shortage;
- Problem with the internal or
external wiring
- Check electric Energy source.
- Call Technical Assistance.
- Burnt smell or smoke.
- Problem with the internal or
external wiring.
- Call Technical Assistance.
- The equipment switches
ON but when the product is
placed it stops or turn slowly.
- Problem with the Electric
motor.
- Crown grove worn out or
broken.
- Call Technical Assistance;
- Change the crown .
- Damaged cord
- failure during product
transporta
ti
on.
- Call Technical Assistance.
- Unusual noises.
- Damaged bearings.
- Call Technical Assistance.
7
3.3 Cleaning and Sani
ti
zing
IMPORTANT
Before removing or installing the Cup # 02 (Pic.01) be sure the motor has
completely stopped in order to avoid accidents or damage to the product that
might occur.
The Blender is ac
ti
vated by turning the ON/O
ff
Switch # 06 (Pic.01) located on the Housing
# 04 (Pic.01) to ON posi
ti
on.
3.2 Feeding Procedures
The High Performance Blender works at high speed (approximately 22,000 rpm, without
load ). To feed it proceed as follows:
1 – Remove the Lid # 01 (Pic.01).
2 – Put product inside the Cup # 02 (Pic.01) with the machine switched OFF.
3 – Place the Lid # 01 (Pic.01) back on top of the Cup and switch the machine ON.
OBSERVATION
The processing
ti
me varies in accordance to the product processed.
IMPORTANT
NEVER SWITCH THE MACHINE ON WITHOUT LOAD IN IT BECAUSE IT WILL CAUSE
IRREPARABLE DAMAGES.
IMPORTANT
Never do cleaning with the machine plugged in. Always unplug the machine
before cleaning. Before removing the Cup be sure the motor has completely
stopped.