6
1. 2 Main Components
All components are made with carefully selected materials, in accordance with Siemsen
experience and standard tes
ti
ng procedures.
Picture 01
02
06
03
04
01
05
07
01 - Cap
02 - Lid
03 - Cup
04 - Housing
05 - On/off Switch
06 - Feet
07 - General Key
19
6. Norms
The following Norms apply:
ABNT NBR NM 60335-1
IEC 60335-2-64
7. Maintenance
Maintenance must be considered a set of procedures with the purpose to keep the
equipment best opera
ti
ng condi
ti
ons , therefore increasing the equipment life and safety.
* Cleaning – check item 3,3 Cleaning.
* Wiring - Check all wires regarding deteriorate conditions as well as all electric contacts
(terminals) regarding ti
ghtening and corrosion.
*Contacts – ON/OFF switch, emergency butt
on, reset bu
tt
on , electronic circuits etc,
check the equipment in order to assure that all components are correctly working and the
equipment opera
ti
on is normal.
* Installa
ti
on – make sure the installa
tion followed item 2.1 instructi
ons.
1 – Each month check:
- Check the electrical installa
ti
on.
- Measure the voltage at the socket.
- Measure the working current and match it with the nominal current.
- Check the
ti
ghtening of all electric terminals to avoid bad contacts.
- Check electric motor sha
ft
clearance.
- Check the wiring for overheati
ng, insula
ti
on failures and mechanical damages.
2 – Each three month checks:
- Check electrical components such as ON/OFF switch, emergency butt
on, reset bu
tt
on,
electronic and electric circuits, overhea
ti
ng, insula
ti
on failings, or mechanical damages.
- Check bearings clearances.
- Check retainers, O’rings, V’rings and other seals.
