20
6. Maintenance
Maintenance must be considered a set of procedures with the purpose to keep the
equipment best opera
ti
ng condi
ti
ons, therefore increasing the equipment life and safety.
* Cleaning – check item 3,3 Cleaning.
* Wiring - Check all wires regarding deteriorate condi
ti
ons as well as all electric contacts
(terminals) regarding
ti
ghtening and corrosion.
*Contacts – ON/OFF switch, emergency bu
tt
on, reset bu
tt
on, electronic circuits etc ,
check the equipment in order to assure that all components are correctly working and the
equipment opera
ti
on is normal.
* Installa
ti
on – make sure the installa
ti
on followed item 2.1 instruc
ti
ons.
* Equipment life span: 2 years if normal working
ti
me is performed.
1 – Each month check:
- Check the electrical installa
ti
on
- Measure the voltage at the socket
- Measure the working current and match it with the nominal current
- Check the
ti
ghtening of all electric terminals to avoid bad contacts
- Check electric motor sha
ft
clearance
- Check the wiring for overea
ti
ng, insula
ti
on failures and mechanical damages.
2 – Each three month checks:
- Check electrical components such as ON/OFF switch, emergency bu
tt
on, reset bu
tt
on,
electronic electric circuits , overea
ti
ng, insula
ti
on failings, or mechanical damages
- Check bearings clearances
- Check retainers, O’rings, V’rings and other seals
5
1.2 Main Components
All components are made with carefully selected materials, in accordance with Siemsen
experience and standard tes
ti
ng procedures.
PICTURE 01
01 – Chamber Lid
02 – Round Stumper
03 – ON/OFF Switch
04 – Plate Chamber
05 – Oblong Stumper
06 – Lid Fastening
07 – Motor Housing
08 – Plates
09 – Feet
10 – Expeller Dish
06
04
02
08
05
07
03
09
10
01
