7
3.2 Feeding Procedure
To feed the blender proceed as follows:
a - Cut the product in small pieces of up to 2cm size. This process helps on blending time
mainly for frozen products. When triturating ice, it is recommended to drop some water
inside the cup.
b - Take out the lid No. 05 (Picture 02).
c - Place the product to be processed into the cup No.04 (Picture - 02) with the
machine switched OFF.
d - Place the lid back No. 05 (Picture 02) and switch the machine ON.
IMPORTANT
NEVER USE THIS EQUIPMENT TO PROCESS PASTES WITH THICK TEXTURE.
NEVER SWITCH THE MACHINE ON WITHOUT LOAD IN IT BECAUSE IT WILL CAUSE
IRREPARABLE DAMAGES.
You should not:
- Expect your blender to replace any other kitchen appliance. It is not supposed to make
mashed potatoes, it does not blend egg white or any other cream for covering, it does not
grind raw meat, it does not blend hard pastas and do not extract kernels from fruits and
vegetables.
- Process mixtures too long. Remember that the blender works in seconds and not in
minutes. Therefore, never let your blender working for more than one minute. It is better
to switch it off and check the mixing consistency after a few seconds to avoid too much
blending.
- Overload the motor with big or heavy portions as it will make the blender’s life shorter. If
motor stops, switch it off immediately, unplug and remove part of the load before to start
operation again.
3. Operation
3.1 Starting
Start the machine by pressing the ON/OFF switch button , located on the Motor Housing
N° 03 (Pic. 01).
IMPORTANT
Unplug the blender incase of emergencies.