04
Before using the machine all parts that get in contact with food must be washed
with running water and neutral soap. To clean your Blender read item 3.3 Cleaning on this
Manual (pag.4).
3. Operation
3.1 Starting
IMPORTANT
Before removing or installing the Cup Nº02 (Pic.01) be sure the motor has
completely stopped in order to avoid coupling premature wear out.
The Blender is activated by turning the On/Off Switch Nº08 (Pic.01) located at the
Motor Housing Nº05 (Pic.01) to ON position.
3.2 Feeding Procedure
The High Performance Industrial Blender works at high speed (approximately
3.500 rpm 60Hz) . To feed it proceed as follows:
1 - Remove the Lid Nº01 (Pic.01).
2 - Put product inside the Cup Nº02 (Pic.01) with the machine switched OFF.
3- Place the Lid Nº01 (Pic.01) and switch the machine ON.
IMPORTANT
The processing time depends on the kind of product. It is not recommended to
blend products without the addition of any liquid, otherwise it will overheat and
damage the Cup seal.
IMPORTANT
NEVER SWITCH THE MACHINE ON WITHOUT LOAD IN IT BECAUSE IT WILL
CAUSE IRREPARABLE DAMAGES.
Tabla - 02
5.2 Diagrama Eléctrico
Motor
110 ou 220
Volts
Problemas
Causas
Soluções
* Falta de Energia
eléctrica, o enchupe
desconectado de la red
eléctrica.
* Problema en el circuito
e l é c t r i c o i n t e r n o o
externo de la máquina.
* Verifique si el
e n c h u f e e s t á
conectado la toma de
corriente y si hay
energía eléctrica en la
red eléctrica.
* La Máquina no se
prende.
* Va s o p r e s e n t a
filtracion.
* Capacitorde arranque
defectuoso.
* Llame el servicio
técnico.
* Problema en el sistema
de vedamiento.
* Llame el servicio
técnico.
* Llame el servicio
técnico.
Llave Prender/Desligar
*La maquina se prende
pero el motor gira
despacio.
19
