4. Secure the MD-318 inside the lighting fixture and install the lighting fixture back to the original
configuration.
5. Turn the circuit breaker back on and turn on the wall switch that is used to operate this lighting
fixture.
6. The light will be on and you should hear a single beep. The Dimmable Module is installed
properly and you can begin programming transmitter(s) to it.
WARNING:Failure to turn off power at the circuit breaker can result in electrical shock causing severe or
fatal injury.
The Dimmable Receiver Module is designed to operate maximum load of 300W at 120VAC, 60Hz.
3. Programming the Dimmable Receiver Module
-
The Dimmable Receiver Module should be power off
initially.
-
Power on the Dimmable Receiver Module. You will hear
beeping from the Dimmable Receiver Module and the
connected light should be on. The beeping indicates the
Dimmable Receiver Module is now in programming mode
and it will stay in this mode for 20 seconds.
-
Press the PROG button on the back of the transmitter with
a sharp object.
-
Press the button on the transmitter that you would like to
program into the Dimmable Receiver Module.
-
Once the transmitter is programmed, the light will be off.
You have successfully program the transmitter.
‘PROG’ button
4. Operation
The MD-318 allows on / off operation, when the programmed transmitter is activated.
