DIP switches Type Garage Door Opener
1.
Refer to the Table A to select the brand of
garage door opener
2.
Match the DIP switches setting of your existing
remote or garage door opener.
If your garage door opener or remote has the 3-
position DIP switch, DO NOT use the ‘0’ position,
use ‘+’ or ‘-‘. Set the DIP switch in G7M to ‘ON’ for
‘+’ or ‘OFF’ for ‘-‘ respectively.
3.
Hold both buttons at the same time for 5 seconds.
!
You have 15 seconds to setup otherwise start
over again.
4.
Ensure the operating frequency is correct
based on Table A. Otherwise you should
place the rotary switch at a group that
transmits at the proper frequency.
5.
Press the button you want to use.
The LED will be off and you have successfully
setup the G7M to operate your garage door
opener.
Warranty
If, within one year from date of purchase, this
product should become defective (except
battery), due to faulty workmanship or
materials, it will be repaired or replaced,
without charge. Proof of purchase and a
Return Authorization are required.
FCC statement
The device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the product.
IC
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
