
DOOR/WINDOW SENSOR Model 2WD9 PRELIMINARY COPY
1. INTRODUCTION
The door/window sensor model 2WD9 is designed to monitor any door or window within your
house. When the monitored window or door is opened, the sensor will send signal to the receiver
and alert you the status.
In this package, you should find a sensor, a magnet and mounting accessories.
Please follow the instructions below to setup the door/window sensor.
2. INSTALLATION
i)
Remove the top cover of the sensor and insert one AA battery (sold separate) to the sensor
as shown in the diagram.
ii) Before inserting the battery, keep the magnet away from the sensor. After inserting the
battery to the door / window sensor, press and hold the learn button in the receiver unit,
release the button when the receiver emits a beep. The zone red LED on the receiver will
flash.
iii) Move the magnet away from the sensor, the receiver unit will emit a long beep indicating it
has learned the code from the sensor.
MOUNTING LOCATION
The sensor should be mounted on the door/window frame and the magnet should be mounted on
the door/window itself. Mount the sensor or magnet as high as possible. You should find a
marking alignment on one side of the sensor. The magnet should be in contact with this marking
when the door/window is closed.
OPERATION
When the magnetic contact is broken, such as when the door or window is open, the sensor will
send a signal to the receiver, and the receiver will beep and the corresponding zone red LED will
flash.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.