SKYJACK, Page 21
April 2006
SJIII Series E - CONVENTIONALS
Section 2 - Operation
Component Identification (Special Options)
2.3 Component Identification (Special Options)
This following descriptions are for identification, explana-
tion and locating purposes only of optional equipment.
2.3-1 1500W AC Inverter (If Equipped)
Inverter
- The inverter is located on the base of the
machine. It has the following controls:
Figure 2-12. 1500W AC Inverter
Note
The inverter operation is automatic. These
controls do not need to be manipulated
for normal operation.
1.
ON/OFF Switch
- This diagnostic slide switch
activates or terminates inverter operation. It
should remain in the “ON” position.
2.
Status LEDs
- These LEDs indicate the operating
or fault status of the inverter .
3.
15 Amp Circuit Breaker
- In the event of a power
overload or circuit grounding, the circuit breaker
will pop out. Push the breaker back in to reset.
4.
GFCI Outlet
- During inverter operation, this outlet
provides AC power.
2.3-2 Powered Extension Deck Control Box
(If Equipped)
This metal control box is mounted on one of the
extension platform guardrails. It contains the following
controls:
Figure 2-13. Powered Extension
Deck Control Box
1.
Enable Switch
- This switch, when activated and
held, allows the extension deck extend/retract
switch functions to operate.
2.
EXTEND/RETRACT Switch
- This switch, when
activated, extends or retracts the powered
extension deck. Refer to
to extend/retract a powered extension deck.
4
2
1
3
2
1
