-
After all antennas, GPS, and power adapter are connected, power up the
Receiver.
-
If using an iPad or iPhone for your display device, on your Apple device, go into
“Settings” and turn ON Airplane mode.
-
While in “Settings”, turn on WiFi and after a brief search, a WiFi hot spot will
appear showing “SkyGuardTWXxx” where “xx” is a numeric value specific to
your ADS-B receiver.
-
Select this hot spot by tapping on it’s name.
-
Wait for approximately 10 seconds for the Apple device to establish a connection
to the ADS-B receiver over WiFi. If a connection is not established, turn off your
WiFi on the Apple device and power cycle the receiver. Then try again.
-
Close “Settings” on the Apple device.
-
Select either WingX Pro 7, or any other Flight App. that supports the
SkyGuardTWX Vision-Pro UAT/ES Receiver on the Apple device.
-
Configure the selected App. to connect to the ADS-B receiver. Refer to the
specific setup configuration as provide with the Flight App.
-
If you are using an Adventure Pilot IFly 720 GPS as your display device, refer to
the IFly 720 user manual for instructions to connect to the receiver.
-
You are now ready to receive/display any UAT Weather/Traffic on the moving
map of your display device.
-
In order to maximize reception, it is best to place the receiver on the aircraft glare
shield. If this is not possible, you can place the receiver anywhere as long as the
receiver antennas have a clear view out the window and are not obstructed by any
metal panels on your aircraft.
-
If you would like to “remote mount” your receiver, you can purchase additional
remote antennas with extension coax cables from www.SkyGuardTWX.com
Important Pilot Advisory Note Regarding Safety of Radio Frequency Energy:
FCC Compliance Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate this equipment under FCC rules.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for a
