Skybrake DD2+ User Manual Download Page 2

versija 01, 1.06.2008_120114

soon as panic starts. Driving will not be possible until the PT is 

within range of the system or the personal emergency disabling 

code (PIN) is used.

the anti-theft function is prohibited within the territory of 

the russian Federation and the eu.

If the ANTI-THEFT FUNCTION is enabled, after you switch on the 

ignition, the silence or two sound signals will confirm the pre-

sence of the PT within range. 

Anti-theft function can be enabled/disabled only by certified in-

staller.

emergency system disabling

To  use  the  vehicle  without  a  PT  you  will  require  a  special  PIN 

code consisting of four digits (for example, 3241). The system 

manufacturer will give you a card with the PIN code.

l

 Turn on the ignition;

l

 Wait until the series of warning signals emits inside the vehic-

le (panic mode);

l

 Turn off the ignition and prepare to enter the PIN code;

l

 Turn  on  the  ignition,  when  the  warning  signals  series  emit 

start counting them, when the number of sound signal series 

aligns with the first digit of the PIN code (e.g. 3), turn off the ig-

nition (the first digit of the PIN code has been entered);

l

 Turn on the ignition and continue counting the sound signal 

series until their number aligns with the second digit of the PIN 

code – (e.g. 2), then turn off the ignition;

l

 Turn on the ignition and repeat the above steps with the third 

(4) and fourth (1) digits of the PIN code;

l

 When turning on the ignition after entering the last PIN code 

digit, you will hear a sound signal – the SKYBRAKE DD2+ system 

is disabled;

l

 The next time you turn off and turn on the ignition, the vehic-

le engine will be immobilized and you will have to repeat the 

PIN code entering procedure;

l

 If you make a mistake while entering the PIN code, with the 

ignition turned on wait for a series of 12 sound signals, turn off/

turn on the ignition and enter the PIN code again;

l

  Use  of  the  PT  automatically  renews  the  normal  operating 

mode of SKYBRAKE DD2+.

checKing the PersonAl trAnsceiver (Pt) 

And Functioning oF the sYsteM

the personal transceiver (Pt) consists of:

Top and bottom casing units;

Element plate;

3 V CR2430 battery.

Note  the  battery  polarity  and  designations  on  the  mounting 

plate contact clamps!

The PT is assembled in the casing in just one non-tensioned po-

sition in order not to damage the element plate. See the figure.

The SKYBRAKE DD2+ set includes two personal transceivers (PT) 

and CR-2430 batteries; however, the batteries are not placed in 

the PT battery contacts.

it should be taken into account that the operating time of 

the  Pt  power  unit  (battery  cr2430)  is  approximately  12 

months. there will be a reminder of the need to replace the 

battery by a distinctive series of three dual audible signals 

which  will  sound  inside  the  vehicle  each  time  after  switc-

hing on the ignition. 

In case the PT is inside the vehicle but the engine cannot be swit-

ched on (it is immobilized), check the condition of the SKYBRA-

KE DD2+ system by doing the following:

l

 Switch off the ignition, open the casing of the PT and remove 

the battery from the element plate;

l

 Put the battery back in the contact holder in line with the in-

dicated polarity;   

 

l

  Observe  the  operation  of  the  LED  on  the  element  side  of 

the PT few seconds after putting in the battery. If it is flashing 

4 times, this means the battery is in good condition. If the LED 

doesn’t flash, replace the battery with a new one; 

l

 Put the battery (1) in the contact holders (2) in line with the 

indicated polarity;

l

 Switch on the ignition and wait for the light to flash again; if 

it flashes, this means there is normal radio contact between the 

system and the PT;

l

 Place the plate in the casing (3) and close it.

PleAse note!

If the vehicle is equipped with the engine remote control system, 

or it is necessary just to warm up the vehicle when the driver is 

not present, you must take into account the following(only with 

motion detector): 

l

 The PT must be located out of range, or you must open the ca-

sing and remove the battery from the element plate;

l

 The vehicle must be parked with the parking brake activated 

and the gear stick must be in parking or neutral position.  

Now you may start the engine.

Correct use of the SKYBRAKE DD2+ immobilizer will not lead to 

the failure of the vehicle’s  systems. 

Keep the PT in a separate place from your car keys and cell pho-

ne.

In case you leave your car for servicing, leave the PT inside the 

vehicle, for example in the glove box.

guArAntee Period

The guarantee for the SKYBRAKE DD2+ is 24 months from the 

date of installation.

The  guarantee  is  valid  in  the  event  that  the  installed  system 

does not work due to the fault of the manufacturer or the ma-

terials used.

The guarantee is not valid in the event that the product has suf-

fered mechanical damage, if it has been liquid cleaned, or if it 

has been incorrectly installed or used.

The guarantee does not apply to the CR2430 power source.

Reviews: