T
ELESCOPE
ASSEMBLY
F
INDERSCOPE
A ASSEMBLY
E
YEPIECE
A ASSEMBLY
4
INSTALLING CONTROL CABLES (6)
1) Slide the sleeve end of the cable over the nipple on
the end of the worm gear. Tighten the cable using the
set screw against the flat surface on the nipple.
INSTALLING COUNTERWEIGHT (5)
1) Slide counterweight halfway onto rod. Hold
the counterweight with one hand and
insert counterweight rod into threaded
hole on mount with the other hand.
Tighten counterweight rod onto mount.
2) Tighten thumbscrew to lock
counterweight in place.
5.
6.
(long)
(short)
ATTACHING THE TUBE RINGS TO MOUNT(7)
1) Remove the telescope tube from its plastic packaging.
2) Remove the tube rings from telescope by releasing their
thumb nuts and opening their hinges.
3) Using the bolts provided, fasten the tube rings to the mount
with the 10mm wench provided.
ATTACHING THE TELESCOPE
MAIN TUBE TO TUBE RINGS (8)
1) Remove the telescope tube from the paper covering.
2) Find the center of balance of the telescope tube. Place this
in between the two tube rings. Close the hinges around the
telescope and fasten securely by tightening the thumb nuts.
7.
8.
ATTACHING THE FINDERSCOPE (9)
1) Locate finderscope optical assembly.
2) Remove the two knurled thumbscrews near
the front of the telescope main body.
3) Position the finderscope bracket over the
screws in the telescope main body.
4) Secure the finderscope bracket with the
two knurled thumbscrews.
9.
INSERTING EYEPIECE (8)
1) Unscrew the thumbscrews on the
end of the focus tube to remove the
black plastic end-cap.
2) Re-tighten thumb screws to hold
eyepieces in place.
10.
