Page 3 of 5
7-
Disconnect the modular cable that is connected to the RCA Phone, at the “
L4/L3”
jack and hold it in your hand. Now connect the cord in your hand, to the
[3&4 To
Line]
jack on the CK-1R Black Box.
8-
Connect one end of one of the supplied modular cords, to the [
1&2 To Phone
]
jack on the CK-1R Black Box. Connect the other end of the modular cord to the
“L2/L1”
jack on the RCA Base Phone.
9-
Connect one end of the other supplied modular cord to the
[3&4 to Phone]
jack
on the CK-1R Black Box. Connect the other end of the modular cord to the
“
L4/L3”
jack on the RCA Base Phone.
10-
The audio cord that comes with the CK1R is ONLY used for CD Players. If you
have a digital player, then you should be using the audio cord that came with your
digital unit. Connect the proper audio cord from your music source, to the
AUDIO IN jack on the CK-1R Black Box.
9- Connect the POWER CUBE from the CK-1R box to 115VAC power. All lights on
Black Box will flash two times and then will turn OFF.
Disabling ON HOLD BEEP on Phone:
When you place a caller ON HOLD, the 25450 phone will BEEP every 30 seconds or so.
This BEEP can be disabled as follows:
1-
From the BASE PHONE, while it is hung up, press the MENU button (On
Display).
2-
Press DOWN ARROW until “SYSTEM SETTING” is displayed.
3-
Press “SELECT” (On Display).
4-
Press DOWN ARROW until “HOLD MESSAGE” is displayed.
5-
Press “SELECT” then “SELECT” again. Wait!
Sensor Board Cable
Base Phone
Modular Phone Cables
CK-1R Black Box
Figure 3
