Version 4.00
Page 13
If the BA-1000-A detects a call to be Urgent, it
will immediately hang up and start searching for
you. It will start by dialing the first pre-programmed
notification number, and will keep calling numbers
until the Urgent call has been reviewed. The BA-
1000-A will keep calling the list of notification
numbers over and over until either: the urgent
message is retrieved or it has called all of the
numbers 20 times each, whichever comes first.
Once the system contacts you, it says;
"
I have an
urgent message from your office. Enter the access
code
"
. Once you enter the
access code
the BA-
1000-A will play you the urgent message.
Setup Mode
Setup Mode is used to set the clock and to
change various system parameters of the BA-1000-
A. It should be noted that changing the system
parameters
WILL
effect the operation of the
machine. You should not change any parameters
that you do not understand or it might cause a
malfunction in the operation.
Call technical
support if you are not sure!
Enter:
888
888
888
888
!
Set CURRENT Time
The first option in System Setup is to set the
current time. The display will show the following:
Set CURRENT Time
1=Change #=Next
You can press then release
1
1
1
1
to change the
current time or
#
#
#
#
to proceed to the next option.
You can press then release
~
~
~
~
to exit
setup mode.
Set The Current Day
If you press then release
1
1
1
1
to change the
time; the display shows:
Enter day, 1 – 7
#=Sunday
The current day will be shown in the bottom of
the display. To change the day, press then release
the corresponding number followed by
#
#
#
#
; i.e.
1
1
1
1
for Sunday,
2
2
2
2
for Monday, etc.
Set The Current Date
Now the display will show:
-- Enter Date –-
# = 01/01/1980
The current date will appear in the bottom of
the display. You can enter a new date followed by
#
#
#
#
, or just press then release
#
#
#
#
to keep the
current date.
Set the Current Time
Now the display will show:
-- Enter time --
- # = 12:00 pm –
The current time will appear in the bottom of
the display. You can enter a new time followed by
#
#
#
#
, or just press then release
#
#
#
#
to keep the
current time. You can change between a.m./p.m. by
pressing then releasing the
*
*
*
*
.
!
Access Code=1234
This is the general access code used to remotely
retrieve messages left on the system, by modes 0, 1
and 3. The display will look as follows:
Access Code=1234
1=Change #=Next
You can press then release
1
1
1
1
to change the
access code, followed by the
#
#
#
#
, or press then
release
#
#
#
#
to proceed to the next option. You can
press then release
~
~
~
~
to exit setup mode.
!
Play Only= Off
This controls Announcement Only mode.
When
ON
, the unit will answer the phone, play the
outgoing message, and will hang up without
recording a response. The display will look as
follows:
