14
Servicing
User Manual
SKOPE B600-2/B600G-2
Sign Light
B600G-2 only. The sign unit is lit by one 11 Watt T8 LED tube (Ø26mm x
600mm), which can be replaced by removing the front sign panel.
To replace the sign light
1. Remove the front panel and isolate the chiller from the mains power supply
(see page 12).
2. Remove the sign assembly. Lift the assembly up and off the sign sides and
unplug it from the cabinet.
3. Remove the sign top
cover by undoing the
fixing screws from the top
of the sign assembly.
4. Slide the clear front panel
(and artwork if present) up
and out of the sign
assembly.
5. Undo the two inner
lampholder fixing screws
from the rear of the sign
assembly.
6. Loosen the two outside
screws (vertical slot
screws) and slide the
lampholder brackets (and
LED tube) to the bottom of
the vertical slots.
7. Rotate and remove the
failed LED tube.
8. Fit the new LED tube.
9. Slide the lampholder brackets (and LED tube) to the top of the vertical slots
and tighten the outside screws (vertical slots screws).
10. Screw the two inner screws back into the assembly to fix the lampholder
brackets (and LED tube) in place.
11. Refit the clear front panel (and artwork if present) and screw the sign top
cover back onto the top of the sign assembly.
12. Plug the sign assembly back into the cabinet and slot the assembly back
onto the sign sides.
Screw driver
Sign top cover
Sign Assembly
Screw driver
Inner screw (remove)
Outer screw (loosen)
Sign assembly (back)
Vertical slot
Lamp holder bracket
Lamp holder
LED tube
